Line Heater – 2.7 MM BTU – NRG 359

1. SHELL – Reconditioned

72” OD x 22’-6” Long with Bolted Ends
C/w 24” OD x 60” Horizontal Expansion Tank
Lineheater Shell Covered with 1 ½” Fiberglass Insulation C/w 0.020 Stucco Embossed Aluminum Cladding
C/w Ladder to Access the Expansion Tank.
C/w 8” Thief Hatch Connection
c/w original 1” preheat coil

2. FIRETUBE

One (1) 24” OD Firetube “U” Type Fire Tube
2.7 MMBTU/hr based on Flux Rate of 10,000 BTU per hr. / per sq. ft.
C/w 2.7MM BTU Flame Arrestor Burner
C/w Exhaust Stack
Reconditioned-firetube, stack and flam arrestor
4” Eclipse main and pilot burners.

3. COILS

Built New to Suit
Coils registered in Alberta
Coils are 100% Radiography
No PWHT

4. BURNER SYSTEM

NOTE: CSA B149.3 COMPLIANT CONTROLS
Field certification required
As per the new rules for B149.3 field certification must be completed by the owner.
Please forward confirmation to us once this is completed.
If you would like us to complete it, we will provide this service at cost plus 10%.

PACKAGING SPECIFICATIONS

-Relief valves piped outside
-Piping to skid edge c/w individual connections
-Package is readied or dismantled only to the extent required for shipping
-All piping, instrument tubing and equipment will be adequately supported
-All flange and open ends of piping will be covered for shipment
-All instruments to be vented off skid individually
-Sweet Fuel Gas is 1” Threaded provided off skid @ Max 150 Psig
-Shop UT of Line Heater Shell, Original Preheat Coil, Expansion Tank, and Firetube
-Washout of Aluminum Flame Arrestor
-New Burner Train, Nozzle, and Burner Management System